![]() ![]() It was time to make a decision of how things would fit together. I glued these to the skeleton so that I'd have better surfaces for attaching the outer piece.Įverything looked pretty good, but there was a weird overhang at the top. ![]() Since it was difficult to get a good glue seal against the brace I had made, I used a heat gun on some small PVC board pieces to create brackets. Once I felt pretty good about the placement, I installed PVC board across the top of the window to hold things in place - careful not to glue this down to the back section. Using the table saw, I cut some MDF board to serve as the window frames, and as I taped everything together, I began to get a feel for where everything should go. My table saw was also helpful at one point.īut enough of that, let's start planning!
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |